Side-Power 8981 Manuál s instrukcemi stáhnout pdf (Strana 15)

8981FS Instruction Manual 9

Conﬁguration

This section describes:

■

Onboard conﬁguration hardware (switches and LEDs),

■

Module operation modes and appropriate setups,

■

Using the onboard switches to make conﬁguration settings, and

■

Remote conﬁguration and monitoring using the 8900NET interface.

Conﬁguration Switches and LEDs

The 8981FS module can be conﬁgured locally using the onboard rotary and

toggle switches shown in Figure 5. Two LEDs are used to indicate status of

the conﬁguration process. These four components perform the following:

■

Function (rotary) switch – addresses a desired function for conﬁgura-

tion and provides two sets (banks) of 16 functions (0 through 9, A

through F), although not all positions are used.

Note

The Function switch should be kept in position 0 or F when not in use to avoid

any inadvertent change in conﬁguration. 0 and F are inactive positions.

■

2nd FUNC (second function) LED – when on, indicates that the rotary

switch is addressing the second bank (Bank 2) of functions (see Table 3

on page 15).

■

SW1 (toggle) switch – actuates or selects the desired setting for the

selected function when the switch is pushed momentarily in either the

Up or Down position.

■

CONF (conﬁguring) LED – when on, indicates the module is initial-

izing or processing conﬁguration information.

Note

Function switch position E (Restore) in Bank 2 can be used to return the

module conﬁguration to the factory default (as shown in Table 3 on page 15).

Conﬁguration can also be performed using the 8900NET with GUI. Remote

control can, however, be locked out using the jumper (J5) shown in Table 5

on page 10.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Žádné komentáře

Side-Power 8981 Manuál s instrukcemi Strana 15