Side-Power RC-10E Uživatelský manuál stáhnout pdf (Strana 8)

Installation & User Manual, Radio Remote RC10E Page 8

WARNING:

Before working on the transmitter, deactivate the transmitter and the receiver (push “OFF” on the

transmitter(s)) and turn off the power to the receiver as well as the thruster mainswitch.

1. Open the transmitter.

2. Take out the battery by inserting a screwdriver or similar between battery and holder at point A,

and gently ip the battery out, taking care not damaging the battery grips at point B

3. Insert the new battery (Type CR2032, 3V - Brand name recommended). Be sure to insert the

battery with the positive pole up diagonally into the battery holder, conrming that the edge of

the battery is under the battery grips (B). Press the battery down until secured at point A.

4. Close the transmitter. Put the cover back in place, ensure that the rubber seal between remote

upper and lower part is located correctly. Place the 3 screws (remember sealing washer) in

their recessed holes and tighten.

Replacingthebattery

Battery

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Side-Power RC-10E Uživatelský manuál Strana 8