Side-Power SEP 100/185 T Servisní příručka stáhnout pdf (Strana 261)

Section 922

GARMIN GTN 635/650/750

Page Date: 6. November 2012 922 - 11

Pilot´s Operating Handbook

EXTRA 330LX

STANDBY

1. Touch the Mode key to show a list of available modes (directly accessible from the

transponder operation page on the GTN 750). Touch the Standby key to place the transponder

into Standby mode. The transponder will still be powered, but will not transmit information. The

active transponder indication and Ident annunciation will be grayed to show they are disabled.

GROUND

1. Touch the Ground key to place the transponder into Ground mode. Mode S replies will be

allowed in Ground mode.

1. Touch the On key for Mode A operation. The transponder is "On" and will transmit its squawk

code when interrogated.

ALTITUDE REPORTING

1. Touch the Altitude Reporting key for Mode C operation.

2. The transponder will be "On" and will transmit its squawk code and altitude when interrogated.

An "ALT" annunciation will appear when the squawk code is transmitted.

VFR

1. Touch the VFR key to set the VFR squawk code (1200 or 7000 depending on location, see

below).

SELECTING A SQUAWK CODE

The selected squawk code will always be in use. As you change the squawk code, the original code

will be used untill you are finished selecting the new code.

1. Touch the transponder squawk code window at the top of the display.

2. The XPDR page will be displayed. The Squawk Code value will be active for selection for use by

the active transponder.

3. Touch the numeric keypad, or use the rotary knobs, to select the desired Squawk Code.

4. Then, touch Enter or press the small right knob.

5. The selected Squawk Code will be shown in the XPDR window at the top of the display.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 283 284

Žádné komentáře

Side-Power SEP 100/185 T Servisní příručka Strana 261