Side-Power SEP 100/185 T Servisní příručka stáhnout pdf (Strana 272)

Section 923

f.u.n.k.e TRT800H Transponder

923 - 6 Page Date: 12. March 2014

Pilot´s Operating Handbook

EXTRA 300LC

923.1.3 DISPLAY-CONTRAST

In active mode (not standby) press for 2 s.

Display indicates “CON” Now adjust contrast (CON) with rotary knob.

Return to normal operation: press or wait 5 s.

923.1.4 FLIGHT-ID (FID)

The FID is an identifier required for Mode S Operation. During future application of flight plans a

FID could be assigned on a per flight basis. If no FID is assigned (today’s normal case) the

registration marking of the aircraft should be used as FID. The FID should not contain dashes

or blanks. The FID must not be confused with the 24-bit Aircraft Address.

923.1.5 DISPLAY FLIGHT-ID

Press MODE (repeatedly) until „STBY“ appears

Press and hold ID while a counter is shown beside the active squawk.

During a few seconds Flight Identification is displayed.

923.1.6 CONFIGURE FLIGHT-ID

Press MODE (repeatedly) until „STBY“ appears

Press and hold ID while a counter is shown beside the active squawk.

Release ID when “CHANGE FID” is displayed

N O T E

Enter FID left-aligned, without any blanks or dashes (!), e.g. 12345621DEFAV for the

marking D-EFAV. The last remaining digits shall be filled with blanks.

Enter Flight-Id with and rotary knob.

Press MODE to save and return to STBY

Please refer to TRT800H Operation and Installation Manual (Doc. No. 03.2125.010.71e) Section

4.5.4 for configuration of the 24-bit Address (AA) and Aircraft Category (AC).

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 283 284

Žádné komentáře

Side-Power SEP 100/185 T Servisní příručka Strana 272